The Latest Tools & Technology to Repair FACE ID!

Don't miss your email and connect your friends with TalkKing!

I2C FACE ID V8 PROGRAMMER FIXTURE FOR IPHONE X/XS/XSMAX/XR/11/11PRO/11PROMAX

Notice:
1: The flex cable can only be used with the IFace V8 programmer;
2: The flex cable cannot be used separately;
3: If there is no programmer, the flex cable can not be used.

Iface V8 Programmer Fix iphone Face ID Not working on X-11 pro max, Face ID Repair Tool - Iface Pro V8 Programmer, don't need disassemble & Reballing the encrypted chip, just replace the dot matrix cable, repair iPhone Face ID issues no working.

Operation Process

1. Connect with original flex cable, press ‘Test’ button to test the flex cable condition

2. Press ‘Read’ button to read and save the data (Do not power off during the operation process to avoid loss of data )

3. Connect the i2C dot projector flex cable with host machine, then press ‘Write’ button to write the data. (Do not power off during the operation process to avoid loss of data)

4. Cut off the shielding cover soldering joint pads with grinding pen

5. Heat with hot air gun and separate the dot projector board from the glass lens with sculpture knife

6. Take down the MOSFET then short the pin as shown in the figure

7. Reball the pads on the flex cable

8. Apply solder paste then solder the dot projector board to the flex cable

9. Test the flex cable working condition after the soldering

10. Put the flex cable into shielding cover and keep the flex well aligned with glass lens